Koi-Kote is a surface tolerant coating but as with all materials the better the surface preparation, the better the performance and longevity.

For concrete,the latency should be removed by mechanical abrasion.

For screeded ponds remove loose dust. Note: When using sharp sand render, remember to sponge finish the surface and when using fibres in render these should be burnt off prior to application.

For GRP, the surface will require abrading.

Koi-Kote comes in pre-measured amounts; mix A & B until a consistent colour is achieved; a power mixer is necessary to achieve thorough mixing. Do not mix too fast or for too long as it produces heat that will shorten its usable life.

Koi-Kote is available from Aquakote Systems Ltd and may be applied by brush or roller, in 2 coats to achieve a Dry Film Thickness (DFT) of between 300 and 500 microns. Normally at 20-25°C, Koi-Kote will be touch dry in two hours and the final coat may be applied. The pond may be refilled when the 2nd coat is hard (cured). Temperature will affect the cure time as A + B is a chemical reaction:

High temperature 20 – 25°C, short pot life

Low temperature 5 – 10°C, long pot life

When cured, wash with hot soapy water and rinse thoroughly prior to introducing fish.

A 2 Kilo unit of Koi-Kote will provide a theoretical DFT of 200 microns on an area of 6.6m² for a single coat. Allowance must be made for rough or absorbent surfaces etc.

If you have a specific project in mind, please use our contact page to request a quotation or ask for advice.

Blue, Grey, Black, British Racing Green or Clear.

Any colour may be used as a base coat or top coat, however for clear applications the same Clear product should be used for each.

Stored in a cool dry place Koi-Kote can be kept un-opened for up to one year from date of purchase.

For safety information please see our separate Safety Data Sheets.